Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 470

www.dell.com | support.dell.com Example Figure 15-22. portmode hybrid configuration example Force10(conf)#interface gi 7/0 Force10(conf-if-gi-7/0)#portmode hybrid Force10(conf-if-gi-7/0)#interface vlan 10 Force10(conf-if-vl-10)#untagged gi 7/0 Force10(conf-if-vl-10)#interface vlan 20 Force10(conf-if-vl-20)#tagged gi 7/0 Force10(conf-if-vl-20)# Usage Information Example The figure above sets a port as hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN of the port. The port will now accept: • untagged frames and classify them as VLAN 10 frames • VLAN 20 tagged frames The next figure is an example show output with "Hybrid" as the newly added value for 802.1QTagged. The options for this field are: • True-port is tagged • False-port is untagged • Hybrid-port accepts both tagged and untagged frames Figure 15-23. Display the Tagged Hybrid Interface Force10(conf-if-vl-20)#do show interfaces switchport Name: GigabitEthernet 7/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 Force10(conf-if-vl-20)# The figure below is an example unconfiguration of the hybrid port using the no portmode hybrid command. Note: You must remove all other configurations on the port before you can remove the hybrid configuration from the port. Example Figure 15-24. Unconfigure the hybrid port Force10(conf-if-vl-20)#interface vlan 10 Force10(conf-if-vl-10)#no untagged gi 7/0 Force10(conf-if-vl-10)#interface vlan 20 Force10(conf-if-vl-20)#no tagged gi 7/0 Force10(conf-if-vl-20)#interface gi 7/0 Force10(conf-if-gi-7/0)#no portmode hybrid Force10(conf-if-vl-20)# Related Commands show interfaces switchport switchport vlan-stack trunk Display the configuration of switchport (Layer 2) interfaces on the switch. Place the interface in a Layer 2 mode. Specify an interface as a trunk port to the Stackable VLAN network. 470 | Interfaces