Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 478
show interfaces Command Example for 1G SFP Interface, Example, Usage, Information
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 478 highlights
www.dell.com | support.dell.com Example Figure 15-29. show interfaces Command Example for 1G SFP Interface Force10#show interfaces gigabitethernet 2/0 GigabitEthernet 2/0 is up, line protocol is down Hardware is Force10Eth, address is 00:01:e8:41:77:95 Current address is 00:01:e8:41:77:95 Pluggable media present, SFP type is 1000BASE-SX Wavelength is 850nm Interface index is 100974648 Port will not be disabled on partial SFM failure Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit Flowcontrol rx on tx on ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 1w0d5h Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes 0 Vlans 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 0 packets, 0 bytes, 0 underruns 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 1w0d5h Force10# Example Figure 15-30. show interfaces Command Example for 10G SFP+ Interface in C-Series Force10#show interfaces tengigabitethernet 0/44 TenGigabitEthernet 0/44 is down, line protocol is down Hardware is Force10Eth, address is 00:01:e8:32:44:26 Current address is 00:01:e8:32:44:26 Pluggable media present, SFP+ type is 10GBASE-CU5M Medium is MultiRate Interface index is 45417732 Force10# Usage Information Related Commands On the C-Series and S-Series, the interface counter "over 1023-byte pkts" does not increment for packets in the range 9216 > x < 1023. show interfaces configured show interfaces linecard show interfaces phy show interfaces rate show interfaces switchport show inventory (C-Series and E-Series) show inventory (S-Series) show ip interface Display any interface with a non-default configuration. Display information on all interfaces on a specific line card. Display information of either rate limiting or rate policing on the interface. Display Layer 2 information about the interfaces. Display the chassis type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display the S-Series switch type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display Layer 3 information about the interfaces. 478 | Interfaces