Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 456

www.dell.com | support.dell.com interface ManagementEthernet c e Configure the Management port on the system (either the Primary or Standby RPM). Syntax interface ManagementEthernet slot/port Parameters slot/port Enter the keyword ManagementEthernet followed by slot number (0-1) and port number zero (0). Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced for C-Series Introduced for E-Series Example Figure 15-7. interface ManagementEthernet Command Example Force10(conf)#interface managementethernet 0/0 Force10(conf-if-ma-0/0)# Usage Information Related Commands You cannot delete a Management port. The Management port is enabled by default (no shutdown). Use the ip address command to assign an IP address to the Management port. management route duplex (Management) speed (Management interface) Configure a static route that points to the Management interface or a forwarding router. Clear FIB entries on a specified line card. Clear FIB entries on a specified line card. interface null c e s Configure a Null interface on the switch. Syntax interface null number Parameters number Enter zero (0) as the Null interface number. Defaults Not configured; number = 0 Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series 456 | Interfaces