Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 299

restart-time seconds stale-path-time seconds role receiver-only Enter the keyword restart-time followed by the maximum number of seconds needed to restart and bring-up all the peers. Range: 1 to 3600 seconds Default: 120 seconds Enter the keyword stale-path-time followed by the maximum number of seconds to wait before restarting a peer's stale paths. Default: 360 seconds. Enter the keyword role receiver-only to designate the local router to support graceful restart as a receiver only. Defaults as above Command Modes ROUTER BGP Usage This feature is advertised to BGP neighbors through a capability advertisement. In receiver only mode, Information BGP saves the advertised routes of peers that support this capability when they restart. Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series neighbor local-as c e s Configure Internal BGP (IBGP) routers to accept external routes from neighbors with a local AS number in the AS number path Syntax neighbor {ip-address | peer-group-name} local-as as-number [no-prepend] To return to the default value, use the no neighbor {ip-address | peer-group-name} local-as command. Parameters ip-address peer-group-name as-number no prepend Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to set the advertisement interval for all routers in the peer group. Enter the AS number to reset all neighbors belonging to that AS. Range: 0-65535 (2-Byte) or 1-4294967295 (4-Byte) or 0.1-65535.65535 (Dotted format) Specifies that local AS values are not prepended to announcements from the neighbor. Defaults Not configured. Command Modes ROUTER BGP Related Commands bgp four-octet-as-support Enable 4-Byte support for the BGP process. Border Gateway Protocol IPv4(BGPv4) | 299