Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 226

www.dell.com | support.dell.com Defaults Command Modes Command History any mac-source-address mac-source-address-mask count byte log monitor Enter the keyword any to filter all packets. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to log the packets. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Not configured. CONFIGURATION-MAC ACCESS LIST-STANDARD Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Added monitor option Introduced for E-Series Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. Usage Information Related Commands When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. deny permit Configure a filter to drop packets. Configure a filter to forward packets. Extended MAC ACL Commands When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. c and s platforms (except the S55 system) support Ingress MAC ACLs only. The supports both Ingress and Egress MAC ACLs. 226 | Access Control Lists (ACL)