Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 224

www.dell.com | support.dell.com Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced for E-Series Usage Information FTOS supports one ingress and one egress MAC ACL per interface. Prior to 7.8.1.0, names are up to 16 characters long. The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. C-Series and S-Series support ingress ACLs only. Example Figure 7-7. Command Example: mac-access-list standard Force10(conf)#mac-access-list access-list standard TestMAC Force10(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark seq Sequence numbers show Show Standard ACL configuration permit c e s Configure a filter to forward packets from a specific source MAC address. Syntax permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log] [monitor] Parameters To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {any | mac-source-address mac-source-address-mask} command. any mac-source-address Enter the keyword any to forward all packets received with a MAC address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. 224 | Access Control Lists (ACL)