Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1070

www.dell.com | support.dell.com priority c e s Specify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during the MASTER election process. Syntax priority priority To return to the default value, enter no priority. Parameters priority Enter a number as the priority. Enter 255 only if the router's virtual address is the same as the interface's primary IP address (that is, the router is the OWNER). Range: 1 to 255. Default: 100. Defaults 100 Command Modes VRRP Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. If you set the priority to 255 and the virtual-address is not equal to the interface's primary IP address, an error message appears. show config c e s View the non-default VRRP configuration. Syntax show config [verbose] Parameters verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration information, including defaults. Command Modes VRRP Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series 1070 | Virtual Router Redundancy Protocol (VRRP)