Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 448
dampening, Related, Commands, Syntax, Parameters, Defaults, Command Modes, History, Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
www.dell.com | support.dell.com Related Commands show config Display the configuration of the selected interface. dampening c e s Configure dampening on an interface. Syntax dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-suppress-time]] To disable dampening, use the no dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-suppress-time]] command syntax. Parameters half-life reuse-threshold suppress-threshold max-suppress-time Enter the number of seconds after which the penalty is decreased. The penalty is decreased by half after the half-life period expires. Range: 1 to 30 seconds Default: 5 seconds Enter a number as the reuse threshold, the penalty value below which the interface state is changed to "up". Range: 1 to 20000 Default: 750 Enter a number as the suppress threshold, the penalty value above which the interface state is changed to "error disabled". Range: 1 to 20000 Default: 2500 Enter the maximum number for which a route can be suppressed. The default is four times the half-life value. Range: 1 to 86400 Default: 20 seconds Defaults Disabled Command Modes INTERFACE (conf-if-) Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Force10(conf-if-gi-3/2)#dampening 20 800 4500 120 Force10(conf-if-gi-3/2)# 448 | Interfaces