Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 229

Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Support added for S-Series Support added for C-Series Introduced for E-Series Usage The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation Information for detailed specification on entries allowed per ACL. Prior to 7.8.1.0, names are up to 16 characters long. Example Figure 7-8. Command Example: mac-access-list extended Force10(conf)#mac-access-list access-list extended TestMATExt Force10(config-ext-macl)#remark 5 IPv4 Force10(config-ext-macl)#seq 10 permit any any ev2 eq 800 count bytes Force10(config-ext-macl)#remark 15 ARP Force10(config-ext-macl)#seq 20 permit any any ev2 eq 806 count bytes Force10(config-ext-macl)#remark 25 IPv6 Force10(config-ext-macl)#seq 30 permit any any ev2 eq 86dd count bytes Force10(config-ext-macl)#seq 40 permit any any count bytes Force10(config-ext-macl)#exit Force10(conf)#do show mac accounting access-list snickers interface g0/47 in Extended mac access-list snickers on GigabitEthernet 0/47 seq 10 permit any any ev2 eq 800 count bytes (559851886 packets 191402152148 bytes) seq 20 permit any any ev2 eq 806 count bytes (74481486 packets 5031686754 bytes) seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets 797843521 bytes) Related Commands mac access-list standard show mac accounting access-list Configure a standard MAC access list. Display MAC access list configurations and counters (if configured). permit c e s Configure a filter to pass packets matching the criteria specified. Syntax permit {any | host mac-address | mac-source-address mac-source-address-mask} {any | host mac-address | mac-destination-address mac-destination-address-mask} [ethertype operator] [count [byte]] | [log] [monitor] Parameters To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {any | host mac-address | mac-source-address mac-source-address-mask} {any | mac-destination-address mac-destination-address-mask} command. any host mac-source-address Enter the keyword any to forward all packets. Enter the keyword host followed by a MAC address to forward packets with that host address. Enter the source MAC address in nn:nn:nn:nn:nn:nn format. Access Control Lists (ACL) | 229