Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 623
mac-address-table station-move time-interval, mac-address-table station-move refresh-arp, mac cam
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 623 highlights
Usage For information on the specific trap sent and the corresponding Syslog refer to Appendix , . Information mac-address-table station-move time-interval e Reduce the amount of time FTOS takes to detect aged entries and station moves. Syntax [no] mac-address-table station-move time-interval number Parameters time-interval number Select the interval of the successive scans of the MAC address table that are used to detect a aged entries and station moves. Range: 500 to 5000ms Defaults 5000ms Command Modes CONFIGURATION Command History Version 7.8.1.0 Introduced on E-Series Usage Information FTOS takes 4 to 5 seconds to detect aged entries and station moves because the MAC address table scanning routine runs every 5000 ms by default. To achieve faster detection, reduce the scanning interval. mac-address-table station-move refresh-arp c e s Ensure that ARP refreshes the egress interface when a station move occurs due to a topology change. Syntax [no] mac-address-table station-move refresh-arp Defaults No default values or behavior Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S55. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage See the "NIC Teaming" section of the Layer 2 chapter in the FTOS Configuration Guide for details on Information using this command. mac cam fib-partition e Reapportion the amount of Content Addressable Memory (CAM) available for MAC address learning (FIB) versus the amount available for MAC ACLs on a line card. Syntax mac cam fib-partition {25 | 50 | 75 | 100} slot-number Layer 2 | 623