Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 732

www.dell.com | support.dell.com Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 26-4. Command Example: show config Force10(conf-router_ospf)#show config ! router ospf 3 passive-interface FastEthernet 0/1 Force10(conf-router_ospf)# show ip ospf c e s Display information on the OSPF process configured on the switch. Syntax show ip ospf process-id [vrf vrf name] Parameters process-id vrf name Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. E-Series Only: Show only the OSPF information tied to the VRF process. Command Modes EXEC EXEC Privilege Command History Version 8.3.5.0 Version 7.9.1.0 Version 7.9.1.0 Version 7.8.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced VRF Introduced VRF Introduced support of Multi-Process OSPF. Introduced process-id option, in support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage If you delete all the network area commands for Area 0, the show ip ospf command output will not list Information Area 0. Example Figure 26-5. Command Example: show ip ospf process-id Force10>show ip ospf 1 Routing Process ospf 1 with ID 11.1.2.1 Supports only single TOS (TOS0) routes It is an autonomous system boundaryrouter SPF schedule delay 0 secs, Hold time between two SPFs 5 secs Number of area in this router is 1, normal 1 stub 0 nssa 0 Area BACKBONE (0.0.0.0) Number of interface in this area is 2 SPF algorithm executed 4 times Area ranges are Force10> 732 | Open Shortest Path First (OSPFv2 and OSPFv3)