Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 152

www.dell.com | support.dell.com util-threshold cpu (S-Series) s Configure the high or low CPU utilization thresholds for SNMP traps. Syntax util-threshold cpu {5sec | 1min | 5min} {Management-unit | standby | stack-unit unit-number | all} {high {0-100} | {low [0-100}}} To return to the default setting, enter no util-threshold cpu. Parameters cpu utilization time Enter the keyword that indicates the amount of threshold time to configure the CPU utilization thresholds. • 5sec • 1min • 5min unit Indicate the unit where you want to configure the CPU utilization thresholds. • Management-unit • standby • stack-unit unit-number = select the number of the unit in the stack • all = use all of the units to configure the cpu utilization information. utilization threshold in % Indicate the high or low values for the CPU utilization threshold in percentage format. • high. Range: 0 - 100 • low. Range: 0 - 100 Note: A threshold level of 0 will disable the syslog and SNMP trap. Defaults High threshold default = 1 minute = 85%; 5 minutes = 80% Low threshold default = 1 minute = 75%; 5 minutes = 70% Command Modes CONFIG Command History Version 8.3.3.8 Version 8.3.5.3 Version 8.4.2.2 Version 8.4.2.0 Version 8.4.1.0 Introduced on S60. Introduced on S55. Introduced on C-Series, S25 and S50. Introduced on E-Series TeraScale. Introduced on E-Series ExaScale. Usage Information When the total CPU utilization exceeds the configured threshold for a given time, a threshold notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is set to the same value as the high threshold value. The system will generate a SYSLOG and SNMP Trap each time the configured threshold is crossed. Related Commands show util-threshold mem Display the set values of the memory utilization thresholds 152 | Control and Monitoring