Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1075
Command, History, Usage, Information, Syntax, Parameters, Defaults, Command Modes, Related, vrrp-group
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1075 highlights
Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced support for telnetting to the VRRP group IP address assigned using this command Introduced on E-Series Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP address is Information configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. vrrp-group c e s Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface. Syntax vrrp-group vrrp-id Parameters vrrp-id Enter a number as the group ID. Range: 1 to 255. Defaults Not configured. Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP address is Information configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. Related Commands virtual-address Assign up to 12 virtual IP addresses per VRRP group. Virtual Router Redundancy Protocol (VRRP) | 1075