Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 153

util-threshold mem (C- and E-Series) c e Configure the high or low memory utilization thresholds for SNMP traps. Syntax util-threshold mem {rp1 | rp2 | cp | lp slot-id | all} {high {0-100} | {low [0-100}} To return to the default setting, use the no util-threshold mem command syntax. Parameters processor type utilization threshold in % Indicate the type of processor that will be used to configure the memory utilization information. • rp1 = route processor1 • rp2 = route processor2 • cp = control processor • lp slot-id = the line card slot-id • all = use all of the processors to configure the memory utilization information. Indicate the high or low values for the memory utilization threshold in percentage format. • high. Range: 0 - 100 • low. Range: 0 - 100 Note: A threshold level of 0 will disable the syslog and SNMP trap. Defaults High threshold default = 92% Low threshold default = 82% Command Modes Command History CONFIG Version 8.4.2.2 Version 8.4.2.0 Version 8.4.1.0 Introduced on C-Series, S25 and S50 Introduced on E-Series TeraScale Introduced on E-Series ExaScale Usage Information When the total memory utilization exceeds the configured threshold for a given time, a threshold notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is set to the same value as the high threshold value. Related Commands To return the memory thresholds to the default values, enter no util-threshold mem rp1 | rp2 | cp | lp number | all show util-threshold mem Display the set values of the memory utilization thresholds Control and Monitoring | 153