Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 146
Command Modes, Command, History, Syntax, Defaults, Usage, Information, telnet-peer-rpm
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
www.dell.com | support.dell.com Command Modes Command History EXEC EXEC Privilege Version 8.3.5.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the S55. Introduced on E-Series ExaScale (IPv6) Increased number of VLANs on ExaScale to 4094 (was 2094) Introduced on E-Series ExaScale (IPv4) Introduced VRF. Introduced on S-Series Introduced on C-Series and added support for IPv6 address on E-Series only telnet-peer-rpm c e Open a Telnet connection to the peer RPM. Syntax telnet-peer-rpm Defaults Not configured. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on E-Series ExaScale Introduced on C-Series Introduced on E-Series Usage Information Opening a telnet connection from the Standby RPM to an Active RPM follows the authentication procedure configured in the chassis. However, opening a telnet connection from the Active RPM into the Standby RPM requires local authentication. Configuring an ACL on a VTY line will block a Telnet session using the telnet-peer-rpm command in the standby to active RPM direction only. Such an ACL will not block an internal Telnet session in the active RPM to standby RPM direction. telnet-peer-stack-unit Open a Telnet connection to the peer stack unit. Syntax telnet-peer-stack-unit Defaults Not configured. Command Modes EXEC EXEC Privilege 146 | Control and Monitoring