Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 254

www.dell.com | support.dell.com Related Commands If you configure the set next-hop command with the interface's (either Loopback or physical) IP address, the software declares the route unreachable. match ip next-hop neighbor next-hop-self Redistribute routes that match the next-hop IP address. Configure the routers as the next hop for a BGP neighbor. set origin c e s Configure a filter to manipulate the BGP ORIGIN attribute. Syntax set origin {igp | egp | incomplete} To delete an ORIGIN attribute setting, enter no set origin. Parameters egp igp incomplete Enter the keyword egp to set routes originating from outside the local AS. Enter the keyword igp to set routes originating within the same AS. Enter the keyword incomplete to set routes with incomplete routing information. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series set tag c e s Configure a filter to specify a tag for redistributed routes. Syntax set tag tag-value To delete a setting, enter no set tag. Parameters tag-value Enter a number as the tag. Range: zero (0) to 4294967295. Defaults Not configured Command Modes ROUTE-MAP Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series 254 | Access Control Lists (ACL)