Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 825

match mac vlan c e s Configure a match criterion for a class map based on VLAN ID. Syntax match mac vlan number Parameters number Enter the VLAN ID. Range: 1-4094 Defaults None Command Modes CLASS-MAP Command History Version 8.3.5.0 Version 8.2.0.1 Introduced on S55 Introduced Usage You must first enter the class-map command in order to access this command. You can match against Information only one VLAN ID. Related Commands class-map Create/access a class map. policy-aggregate c e s Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (input/output) applied on an interface. Syntax policy-aggregate qos-policy-name To remove a policy aggregate configuration, use no policy-aggregate qos-policy-name command. Parameters qos-policy-name Enter the name of the policy map in character format (32 characters maximum) Defaults No default behavior or values Command Modes CONFIGURATION (policy-map-input and policy-map-output) This command is supported on C-Series, S-Series, and the S55 under policy-map-output only. Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Policy name character limit increased from 16 to 32. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information C-Series and S-Series Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate input/ output QoS policy can co-exist with per queue input/output QoS policies. 1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-police) will apply. Any marking configurations in aggregate input QoS policy will be ignored. Quality of Service (QoS) | 825