Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 413

Version 8.2.1.0 Version 7.4.1.0 Introduced for the C-Series Introduced Usage Information This command causes the Ring Manager to take ownership of these two ports after the configuration is validated by the IFM. Ownership is relinquished for a port only when the interface does not play a part in any control VLAN, that is, the interface does not belong to any ring. Related Commands show frrp Display the Resilient Ring Protocol configuration information member-vlan c e s Specify the member VLAN identification numbers. Syntax member-vlan {vlan-range} To return to the default, use the no member-vlan [vlan-range] command. Parameters vlan-range Enter the member VLANs using comma separated VLAN IDs, a range of VLAN IDs, a single VLAN ID, or a combination. For example: Comma separated: 3, 4, 6 Range: 5-10 Combination: 3, 4, 5-10, 8 Defaults No default values or behavior Command Modes CONFIGURATION (conf-frrp) Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on the S55. Introduced for the C-Series Introduced mode c e s Set the Master or Transit mode of the ring. Syntax mode {master | transit} To reset the mode, use the no mode {master | transit} command. Parameters master transit Enter the keyword master to set the Ring node to Master mode. Enter the keyword transit to set the Ring node to Transit mode. Defaults Mode None Command Modes CONFIGURATION (conf-frrp) Command History Version 8.3.5.0 Introduced on the S55. Dell Force10 Resilient Ring Protocol (FRRP) | 413