Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 180

www.dell.com | support.dell.com Related Commands When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs and soft-forwarded, if required, in the following scenarios: • on a Layer 2 interface - if a Layer 3 ACL is applied to the interface. • on a Layer 3 port or on a Layer 2/Layer 3 port ip access-list standard ip access-list extended Configure a standard ACL. Configure an extended ACL. ip control-plane egress-filter Enable egress Layer 3 ACL lookup for IPv4 CPU traffic Syntax Defaults Command Modes Command History ip control-plane egress-filter Not enabled. EXEC Privilege Version 8.3.5.0 Introduced on the S55. show ip accounting access-list c e s Display the IP access-lists created on the switch and the sequence of filters. Syntax show ip accounting {access-list access-list-name | cam_count} interface interface Parameters access-list-name cam_count interface interface Enter the name of the ACL to be displayed. List the count of the CAM rules for this ACL. Enter the keyword interface followed by the interface type and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale and ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Command Modes EXEC EXEC Privilege Command History Version 8.3.5.0 Version 7.6.1.0 Introduced on the S55. Support added for S-Series 180 | Access Control Lists (ACL)