Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 684

www.dell.com | support.dell.com As an Mtrace transit or intermediate router, FTOS returns the response to Mtrace queries. Upon receiving the Mtrace request, FTOS computes the RPF neighbor for the source, fills in the request and the forwards the request to the RPF neighbor. While computing the RPF neighbor, the static mroute and mBGP route is preferred over the unicast route. queue backplane multicast e Reallocate the amount of bandwidth dedicated to multicast traffic. Syntax Parameters queue backplane multicast bandwidth-percentage percentage percentage Enter the percentage of backplane bandwidth to be dedicated to multicast traffic. Range: 5-95 Defaults Command Modes Command History Example 80% of the scheduler weight is for unicast traffic and 20% is for multicast traffic by default. CONFIGURATION Version 7.7.1.0 Introduced on E-Series Figure 24-1. queue backplane multicast Command Example Force10(conf)#queue backplane multicast bandwidth-percent 30 Force10(conf)#exit Force10#00:14:04: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console show run | grep bandwidth queue backplane multicast bandwidth-percent 30 Force10# Related Commands show queue backplane multicast Display the backplane bandwidth configuration about how much bandwidth is dedicated to multicast versus unicast. restrict-flooding e Prevent Layer 2 multicast traffic from being flooded on ports below a specified link speed. Syntax restrict-flooding multicast min-speed speed Parameters min-speed min-speed Enter the minimum link speed that a port must have to receive flooded multicast traffic. Range: 1000 Defaults None Command Modes INTERFACE VLAN Command History Version 7.7.1.0 Introduced on E-Series 684 | Multicast