Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 529

Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Related Commands show ip interface Introduced on the S55. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series Displays the interface routing status and configuration. ip redirects e Enable the interface to send ICMP redirect messages. Syntax ip redirects To return to default, enter no ip redirects. Defaults Disabled Command Modes INTERFACE Command History Version 8.1.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Introduced for E-Series Usage Information This command is available for physical interfaces and port-channel interfaces on the E-Series. Note: This command is not supported on default VLAN (default vlan-id command). ip route c e s Assign a static route to the switch. Syntax ip route vrf {vrf instance} destination mask {ip-address | interface [ip-address]} [distance] [permanent] [tag tag-value] To delete a specific static route, use the no ip route destination mask {address | interface [ip-address]} command. To delete all routes matching a certain route, use the no ip route destination mask command. Parameters vrf name destination mask ip-address (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the VRF Instances name to tie the static route to the VRF instance. Enter the IP address in dotted decimal format of the destination device. Enter the mask in slash prefix formation (/x) of the destination device's IP address. Enter the IP address in dotted decimal format of the forwarding router. IPv4 Routing | 529