Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 853

clear queue statistics egress e Clear egress queue statistics. Syntax clear queue statistics egress [unicast | multicast] [Interface] Parameters unicast | multicast Interface (OPTIONAL) Enter the keyword multicast to clear only Multicast queue statistics. Enter the keyword unicast to clear only Unicast queue statistics. Default: Both Unicast and Multicast queue statistics are cleared. (OPTIONAL) Enter one of the following interfaces to display the interface specific queue statistics. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • Fast Ethernet is not supported Defaults No default behavior or values Command Modes EXEC EXEC Privilege Command History Version 6.2.1.1 Introduced Usage Information If a Policy QoS is applied on an interface when clear queue statistics egress is issued, it will clear the egress counters in show queue statistics and vice-versa. This behavior is due to the values being read from the same hardware registers. Related Commands clear queue statistics egress show queue statistics egress show queue statistics ingress Clear ingress queue statistics Display egress queue statistics Display ingress queue statistics clear queue statistics ingress e Clear ingress queue statistics. Syntax clear queue statistics ingress [unicast [src-card ID [dst-card ID ]] | [multicast] [src-card ID ]] Quality of Service (QoS) | 853