Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 364

www.dell.com | support.dell.com Table 8-18. Command Example fields: show ip bgp ipv4 multicast neighbors Lines beginning with Last read Received messages Sent messages Received updates Minimum time (list of inbound and outbound policies) For address family: BGP table version accepted prefixes Prefix advertised Connections established Last reset Local host: Foreign host: Description This line displays the following information: • last read is the time (hours:minutes:seconds) the router read a message from its neighbor • hold time is the number of seconds configured between messages from its neighbor • keepalive interval is the number of seconds between keepalive messages to help ensure that the TCP session is still alive. This line displays the number of BGP messages received, the number of notifications (error messages) and the number of messages waiting in a queue for processing. The line displays the number of BGP messages sent, the number of notifications (error messages) and the number of messages waiting in a queue for processing. This line displays the number of BGP updates received and sent. Displays the minimum time, in seconds, between advertisements. Displays the policy commands configured and the names of the Route map, AS-PATH ACL or Prefix list configured for the policy. Displays IPv4 Unicast as the address family. Displays the which version of the primary BGP routing table the router and the neighbor are using. Displays the number of network prefixes accepted by the router and the amount of memory used to process those prefixes. Displays the number of network prefixes advertised, the number rejected and the number withdrawn from the BGP routing table. Displays the number of TCP connections established and dropped between the two peers to exchange BGP information. Displays the amount of time since the peering session was last reset. Also states if the peer resets the peering session. If the peering session was never reset, the word never is displayed. Displays the peering address of the local router and the TCP port number. Displays the peering address of the neighbor and the TCP port number. Related Commands Command History show ip bgp Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 View the current BGP routing table. Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series show ip bgp peer-group c et s Enables you to view information on the BGP peers in a peer group. Syntax show ip bgp ipv4 multicast peer-group [peer-group-name [detail | summary]] 364 | Border Gateway Protocol IPv4(BGPv4)