Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 356

www.dell.com | support.dell.com static route-map map-name Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage If you do not configure default-metric command, in addition to the redistribute command, or there is no Information route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate command. Related Commands neighbor default-originate Inject the default route. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series redistribute ospf c et s Redistribute OSPF routes into BGP. Syntax redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name] To stop redistribution of OSPF routes, use the no redistribute ospf process-id command. Parameters process-id match external {1 | 2} match internal route-map map-name Enter the number of the OSPF process. Range: 1 to 65535 (OPTIONAL) Enter the keywords match external to redistribute OSPF external routes. You can specify 1 or 2 to redistribute those routes only. (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal routes only. (OPTIONAL) Enter the keywords route-map followed by the name of a configured Route map. Defaults Not configured. 356 | Border Gateway Protocol IPv4(BGPv4)