Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1057
dei mark, member
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1057 highlights
Usage You must first enable DEI for this configuration to take effect. Information Related Commands dei enable dei mark c s Set the DEI value on egress according to the color currently assigned to the packet. Syntax dei mark {green | yellow} {0 | 1} Parameters 0 | 1 green | yellow Enter the bit value you want to map to a color. Choose a color: • Green: High priority packets that are the least preferred to be dropped. • Yellow: Lower priority packets that are treated as best-effort. Defaults All the packets on egress will be marked with DEI 0. Command Mode INTERFACE Command History Version 8.3.5.0 Version 8.3.1.0 Introduced on S55 Introduced on C-Series and S-Series. Usage You must first enable DEI for this configuration to take effect. Information Related Commands dei enable member c e s Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its configuration. Syntax member interface To remove an interface from a Stackable VLAN, use the no member interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 255 for TeraScale and ExaScale; 1 to 128 for C-Series and S-Series. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults Not configured. Command Mode CONF-IF-VLAN VLAN Stacking | 1057