Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 255

Related Commands Version 7.5.1.0 pre-Version 6.1.1.0 set automatic-tag set level set metric set metric-type Support added for C-Series Introduced for E-Series Compute the tag value of the route. Specify the OSPF area for route redistribution. Specify the metric value assigned to redistributed routes. Specify the route type assigned to redistributed routes. set weight c e s Configure a filter to add a non-RFC compliant attribute to the BGP route to assist with route selection. Syntax set weight weight To delete a weight specification, use the no set weight weight command. Parameters weight Enter a number as the weight to be used by the route meeting the route map specification. Routes with a higher weight are preferred when there are multiple routes to the same destination. Range: 0 to 65535 Default: router-originated = 32768; all other routes = 0 Defaults router-originated = 32768; all other routes = 0 Command Modes ROUTE-MAP Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series Usage If you do not use the set weight command, router-originated paths have a weight attribute of 32768 Information and all other paths have a weight attribute of zero. show config c e s Display the current route map configuration. Syntax show config Command Modes ROUTE-MAP Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Access Control Lists (ACL) | 255