Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1048

www.dell.com | support.dell.com ntp disable c e s Prevent an interface from receiving NTP packets. Syntax ntp disable To re-enable NTP on an interface, enter no ntp disable. Default Disabled (that is, if an NTP host is configured, all interfaces receive NTP packets) Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S55 Support added for S-Series Support added for C-Series Introduced for E-Series ntp multicast client e Configure the switch to receive NTP information from the network via multicast. Syntax ntp multicast client [multicast-address] To disable multicast reception, use the no ntp multicast client [multicast-address] command. Parameters multicast-address (OPTIONAL) Enter a multicast address. If you do not enter a multicast address, the address 224.0.1.1 is configured. Defaults Not configured. Command Modes INTERFACE Command History pre-Version 6.1.1.0 Introduced for E-Series ntp server c e s Configure an NTP time-serving host. Syntax ntp server address [key keyid] [prefer] [version number] To delete an NTP server configuration, use the no ntp server ip-address command. Parameters address key keyid Enter either an IP address, in dotted decimal format, of the NTP time server, or enter the name of the server associated with the IP address. (OPTIONAL) Enter the keyword key and a number as the NTP peer key. Range: 1 to 4294967295 1048 | Time and Network Time Protocol (NTP)