Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 765

ip pim query-interval c e s Change the frequency of PIM Router-Query messages. Syntax ip pim query-interval seconds To return to the default value, enter no ip pim query-interval seconds command. Parameters seconds Enter a number as the number of seconds between router query messages. Default: 30 seconds Range: 0 to 65535 Defaults 30 seconds Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series ip pim register-filter c e s Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified multicast source and group. Syntax ip pim register-filter access-list To return to the default, use the no ip pim register-filter access-list command. Parameters access-list Enter the name of an extended access list. Maximum 16 characters. Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on S55 Introduced on C-Series and S-Series Introduced Usage The access name is an extended IP access list that denies PIM register packets to RP at the source DR Information based on the multicast and group addresses. Do not enter this command before creating the access-list. ip pim rp-address c e s Configure a static PIM Rendezvous Point (RP) address for a group or access-list. Syntax ip pim rp-address address {group-address group-address mask} override To remove an RP address, use the no ip pim rp-address address {group-address group-address mask} override command. PIM-Sparse Mode (PIM-SM) | 765