Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 810

www.dell.com | support.dell.com On one interface, you can configure the rate limit or rate police command for a VLAN or you can configure the rate limit or the rate police command for the interface. For each physical interface, you can configure six rate limit commands specifying different VLANS. If you receive the error message: %Error: Specified VLANs overlap with existing config. after configuring VLANs in the rate police command, check to see if the same VLANs are used in rate limit command on other interfaces. To clear the problem, remove the rate limit configuration(s), and re-configure the rate police command. After the rate police command is configured, return to the other interfaces and re-apply the rate limit configuration. rate police c e s Police the incoming traffic rate on the selected interface. Syntax rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id] Parameters kbps committed-rate burst-KB peak peak-rate vlan vlan-id Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series make the following value a multiple of 64. On the E-Series, Dell Force10 recommends using a value greater than or equal to 512 as lower values does not yield accurate results. The default granularity is Megabits per second (Mbps). Range: 0-10000000 Enter a number as the bandwidth in Mbps. Range: 0 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 16 to 200000 Default: 50 (OPTIONAL) Enter the keyword peak followed by a number to specify the peak rate in Mbps. Range: 0 to 10000 (OPTIONAL) Enter the keyword vlan followed by a VLAN ID to police traffic to those specific VLANs. Range: 1 to 4094 Defaults Granularity for committed-rate and peak-rate is Mbps unless the kbps option is used. Command Mode INTERFACE Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Added kbps option on C-Series, E-Series, and Series. Introduced on S-Series Introduced on C-Series Introduced on E-Series 810 | Quality of Service (QoS)