Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 548

www.dell.com | support.dell.com Example Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S-Series Introduced on C-Series Introduced for E-Series Figure 16-16. show ip interface Command Example Force10#show ip int te 0/0 TenGigabitEthernet 0/0 is down, line protocol is down Internet address is not set IP MTU is 1500 bytes Inbound access list is not set Proxy ARP is enabled Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent Force10# Table 16-12. show ip interface Command Example Items Lines TenGigabitEthernet 0/0... Internet address... IP MTU is... Inbound access... Proxy ARP... Split horizon... Poison Reverse... ICMP redirects... ICMP unreachables... Description Displays the interface's type, slot/port and physical and line protocol status. States whether an IP address is assigned to the interface. If one is, that address is displayed. Displays IP MTU value. Displays the name of the any configured incoming access list. If none is configured, the phrase "not set" is displayed. States whether proxy ARP is enabled on the interface. States whether split horizon for RIP is enabled on the interface. States whether poison for RIP is enabled on the interface States if ICMP redirects are sent. States if ICMP unreachable messages are sent. Figure 16-17. show ip interface brief Command Example (Partial) Force10#show ip int brief Interface IP-Address GigabitEthernet 1/0 unassigned GigabitEthernet 1/1 unassigned GigabitEthernet 1/2 unassigned GigabitEthernet 1/3 unassigned GigabitEthernet 1/4 unassigned GigabitEthernet 1/5 10.10.10.1 GigabitEthernet 1/6 unassigned OK? Method Status Protocol NO Manual administratively down down NO Manual administratively down down YES Manual up up YES Manual up up YES Manual up up YES Manual up up NO Manual administratively down down 548 | IPv4 Routing