Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 249

Command History Related Commands Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series set level set metric set metric-type set tag Specify the OSPF area for route redistribution. Specify the metric value assigned to redistributed routes. Specify the metric type assigned to redistributed routes. Specify the tag assigned to redistributed routes. set comm-list delete c e s Configure a filter to remove the specified community list from the BGP route's COMMUNITY attribute. Syntax set comm-list community-list-name delete To insert the community list into the COMMUNITY attribute, use the no set comm-list community-list-name delete command. Parameters community-list-name Enter the name of an established Community list, up to 140 characters. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced for E-Series Usage Information The community list used in the set comm-list delete command must be configured so that each filter contains only one community. For example, the filter deny 100:12 is acceptable, but the filter deny 120:13 140:33 results in an error. If the set comm-list delete command and the set community command are configured in the same route map sequence, then the deletion command (set comm-list delete) is processed before the insertion command (set community). Prior to 7.8.1.0, names are up to 16 characters long. Related Commands ip community-list Configure community access list. Access Control Lists (ACL) | 249