Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 731

Usage Information You can configure an arbitrary value in the IP address format for each router. However, each router ID must be unique. If this command is used on an OSPF router process, which is already active (that is, has neighbors), a prompt reminding you that changing router-id will bring down the existing OSPF adjacency. The new router ID is effective at the next reload router ospf c e s Enter the ROUTER OSPF mode to configure an OSPF instance. Syntax router ospf process-id [vrf {vrf name}] To clear an OSPF instance, enter no router ospf process-id. Parameters process-id vrf name Enter a number for the OSPF instance. Range: 1 to 65535. (Optional) E-Series Only: Enter the VRF process identifier to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.9.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced VRF Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 26-3. Command Example: router ospf Force10(conf)#router ospf 2 Force10(conf-router_ospf)# Usage Information You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure OSPF. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. show config c e s Display the non-default values in the current OSPF configuration. Syntax show config Command Modes ROUTER OSPF Open Shortest Path First (OSPFv2 and OSPFv3) | 731