Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 79

Command History Version 8.3.5.0 Introduced on the S55. Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage The password is listed in the configuration file; you can view the password by entering the show Information running-config ftp command. The password configured by the ip ftp password command is used when you use the ftp: parameter in the copy command. Related Commands copy ip ftp username Copy files. Set the user name for FTP sessions. ip ftp source-interface c e s Specify an interface's IP address as the source IP address for FTP connections. Syntax ip ftp source-interface interface To delete an interface, use the no ip ftp source-interface interface command. Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 255 for TeraScale and ExaScale • For SONET interface types, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S55. Increased number of VLANs on ExaScale to 4094 (was 2094) Introduced on E-Series ExaScale Support added for S-Series Control and Monitoring | 79