Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 809
rate limit, Usage, Information, Syntax, Parameters, Defaults, Command Modes, Command, History
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 809 highlights
Version 7.5.1.0 Introduced on C-Series pre-Version 6.1.1.1 Introduced on E-Series Usage Information The dot1p-priority command changes the priority of incoming traffic on the interface. The system places traffic marked with a priority in the correct queue and processes that traffic according to its queue. When you set the priority for a Port Channel, the physical interfaces assigned to the Port Channel are configured with the same value. You cannot assign dot1p-priority command to individual interfaces in a Port Channel. rate limit e Limit the outgoing traffic rate on the selected interface. Syntax Parameters Defaults Command Modes Command History rate limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id] kbps committed-rate burst-KB peak peak-rate vlan vlan-id Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On the E-Series, Dell Force10 recommends using a value greater than or equal to 512 as lower values does not yield accurate results.The default granularity is Megabits per second (Mbps). Range: 0-10000000 Enter the bandwidth in Mbps Range: 0 to 10000 (OPTIONAL) Enter the burst size in KB. Range: 16 to 200000 Default: 50 (OPTIONAL) Enter the keyword peak followed by a number to specify the peak rate in Mbps. Range: 0 to 10000 (OPTIONAL) Enter the keyword vlan followed by a VLAN ID to limit traffic to those specific VLANs. Range: 1 to 4094 Granularity for committed-rate and peak-rate is Mbps unless the kbps option is used. INTERFACE Version 8.2.1.0 Version 7.7.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Added kbps option on E-Series. Removed from C-Series Introduced on C-Series Introduced on E-Series Usage Information Note: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on only tagged ports with Layer 2 switched traffic. Quality of Service (QoS) | 809