Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 82
aux 0, console, GigabitEthernet, loopback, port-channel, sonet, Parameters, Defaults, Command Modes
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
www.dell.com | support.dell.com Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 255 for TeraScale and ExaScale • For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.3.5.0 Introduced on the S55. Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094) Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command line c e s Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access conditions for the designated line. Syntax line {aux 0 | console 0 | vty number [end-number]} Parameters aux 0 console 0 vty number end-number Enter the keyword aux 0 to configure the auxiliary terminal connection. Note: This option is supported on E-Series only. Enter the keyword console 0 to configure the console port. The console option for the S-Series is . Enter the keyword vty followed by a number from 0 to 9 to configure a virtual terminal line for Telnet sessions. The system supports 10 Telnet sessions. (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure. You can configure multiple lines at one time. Defaults Not configured Command Modes CONFIGURATION 82 | Control and Monitoring