Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 606

www.dell.com | support.dell.com iscsi target port Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will be monitored. Syntax iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address] To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command. Parameters tcp-port-2...tcpport-16 ip-address Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP port number or a list of TCP port numbers on which the iSCSI target listens to requests. Separate port numbers with a comma. Default: 860, 3260. (Optional) Enter the ip-address that the iSCSI will monitor. The ip-address specifies the IP address of the iSCSI target. Defaults 860, 3260. Command Modes CONFIGURATION Command History Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage Information You can configure up to 16 target TCP ports on the switch in one command or multiple commands. When you use the no iscsi target port command and the TCP port to be deleted is one bound to a specific IP address, the IP address value must be included in the command. show iscsi Display the currently configured iSCSI settings. Syntax show iscsi Command Mode EXEC EXEC Privilege Command History Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4810. Support added for cam modification. Introduced on MXL 10/40GbE Switch IO Module Example FTOS#show iscsi iSCSI is enabled iSCSI session monitoring is disabled iSCSI COS : dot1p is 4 no-remark Session aging time: 10 Maximum number of connections is 256 iSCSI Targets and TCP Ports: 602 | iSCSI Optimization