Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 504

www.dell.com | support.dell.com Usage Information Related Commands This feature groups two LAGs to work in tandem as a supergroup, so that, for example, if one LAG goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For details, see the Port Channel chapter in the FTOS Configuration Guide. group show interfaces port-channel Group two LAGs in a supergroup ("fate-sharing group"). Display information on configured Port Channel groups. show config c e s Display the current configuration of the selected LAG. Syntax show config Command Modes INTERFACE PORTCHANNEL Example Figure 15-43. show config Command Sample Output for a Selected LAG Force10(conf-if-po-1)#show config ! interface Port-channel 1 no ip address shutdown Force10(conf-if-po-1)# Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the S55. Introduced on S-Series Introduced on C-Series Introduced on E-Series show interfaces port-channel c e s Display information on configured Port Channel groups. Syntax show interfaces port-channel [channel-number] [brief] Parameters channel-number brief (OPTIONAL) Enter the number of the port channel to display information on that port channel: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale and ExaScale (OPTIONAL) Enter the keyword brief to display only the port channel number, the state of the port channel, and the number of interfaces in the port channel. Command Modes EXEC EXEC Privilege Command History Version 8.3.5.0 Version 8.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale 504 | Interfaces