Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 619
Layer 2, Overview, MAC Addressing Commands
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 619 highlights
21 Layer 2 Overview This chapter describes commands to configure Layer 2 features. It contains the following sections: • MAC Addressing Commands • Virtual LAN (VLAN) Commands Some MAC addressing commands are supported only on the E-Series, some on all three Dell Force10 platforms, and some on two Dell Force10 platforms. Support is indicated by these characters, where appropriate, under each command heading: c e s The VLAN commands are supported on all three Dell Force10 platforms - c e s MAC Addressing Commands The following commands are related to configuring, managing, and viewing MAC addresses: • clear mac-address-table dynamic • mac accounting destination • mac-address-table aging-time • mac-address-table static • mac-address-table station-move threshold • mac-address-table station-move time-interval • mac-address-table station-move refresh-arp • mac cam fib-partition • mac learning-limit • mac learning-limit learn-limit-violation • mac learning-limit station-move-violation • mac learning-limit reset • show cam mac linecard (count) • show cam maccheck linecard • show cam mac linecard (dynamic or static) • show cam mac stack-unit • show mac-address-table • show mac-address-table aging-time • show mac accounting destination • show mac cam • show mac learning-limit Layer 2 | 619