Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 577

For example, an ACL rule with TCP port range 4000 - 8000 uses 8 entries in the CAM: Rule# Data Mask From To #Covered 1 0000111110100000 1111111111100000 4000 4031 32 2 0000111111000000 1111111111000000 4032 4095 64 3 0001000000000000 1111100000000000 4096 6143 2048 4 0001100000000000 1111110000000000 6144 7167 1024 5 0001110000000000 1111111000000000 7168 7679 512 6 0001111000000000 1111111100000000 7680 7935 256 7 0001111100000000 1111111111000000 7936 7999 64 8 0001111101000000 1111111111111111 8000 8000 1 Total Ports: 4001 But an ACL rule with TCP port lt 1023 takes only one entry in the CAM: Rule# Data Mask From To #Covered 1 0000000000000000 1111110000000000 0 1023 1024 Total Ports: 1024 Related Commands permit permit tcp Assign a permit filter for IP packets. Assign a permit filter for TCP packets. remark c e s Enter a description for an IPv6 ACL entry. Syntax remark remark number [description] To delete the description, use the no remark remark number command (it is not necessary to include the remark description that you are deleting). Parameters remark number description Enter the remark number. Note that the same sequence number can be used for the remark and an ACL rule. Range: 0 to 4294967290 Enter a description of up to 80 characters. Defaults Not configured Command Modes ACCESS-LIST Command History Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced support on the E-Series ExaScale Introduced support on the C-Series Introduced support on the E-Series IPv6 Access Control Lists (IPv6 ACLs) | 577