Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 433

Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to act as an IGMP Proxy Querier. E-Series legacy command ip igmp ssm-map c e s Use a statically configured list to translate (*,G) memberships to (S,G) memberships. Syntax ip igmp ssm-map std-access-list source-address Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) states using the command ip igmp ssm-map std-access-list source-address command. Parameters std-access-list source-address Specify the standard IP access list that contains the mapping rules for multicast groups. Specify the multicast source address to which the groups are mapped. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S55. Introduced on C-Series and S-Series Introduced on E-Series Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When a static SSM map is configured and the router cannot find any matching access lists, the router continues to accept (*,G) groups. Related Commands ip access-list standard Create a standard access list to filter based on IP address. ip igmp static-group c e s Configure an IGMP static group. Syntax ip igmp static-group {group address [exclude [source address]] | [include {source address}]} To delete a static address, use the no ip igmp static-group {group address [exclude [source address]] | [include {source address}]} command. Parameters group address exclude source address include source address Enter the group address in dotted decimal format (A.B.C.D) (OPTIONAL) Enter the keyword exclude followed by the source address, in dotted decimal format (A.B.C.D), for which a static entry needs to be added. (OPTIONAL) Enter the keyword include followed by the source address, in dotted decimal format (A.B.C.D), for which a static entry needs to be added. Note: A group in include mode must have at least one source address defined. Internet Group Management Protocol (IGMP) | 433