Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 354
neighbor route-reflector-client, network
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 354 highlights
www.dell.com | support.dell.com Usage When you apply a route map to outbound routes, only routes that match at least one section of the route Information map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor route-reflector-client c et s Configure a neighbor as a member of a route reflector cluster. Syntax neighbor ip-address | peer-group-name route-reflector-client To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no neighbor ip-address | peer-group-name route-reflector-client command. Parameters ip-address peer-group-name (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. All routers in the peer group receive routes from a route reflector. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage Information The first time you enter this command it configures the neighbor as a route reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a route reflector. When all clients of a route reflector are disabled, the neighbor is no longer a route reflector. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series network c et s Specify the networks for the BGP process and enter them in the BGP routing table. Syntax network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. 354 | Border Gateway Protocol IPv4(BGPv4)