Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 385
Command Output: show cam-acl default, Usage, Information, Syntax, Defaults
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 385 highlights
Version 7.4.2.0 Version 7.4.1.0 Version 6.5.1.0 Version 6.3.1.0 Added the unified-default CAM profile and lag-hash-align microcode Added the lag-hash-mpls microcode Added the eg-default and ipv4-320k CAM profiles Introduced on E-Series Usage Information You must save the running configuration using the command copy running-config startup-config after changing the CAM profile from CONFIGURATION mode. CAM profile changes take effect after the next chassis reboot. Note: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs. Note: Do not make any changes to the CAM profile after you change the profile to ipv4-320K and save the configuration until after you reload the chassis; any changes lead to unexpected behavior. After you reload the chassis, you may make changes to the IPv4 Flow partition. show cam-acl c Display the details of the CAM profiles on the chassis and all line cards. Syntax show cam-acl Defaults None Command Modes EXEC Privilege Command History Version 7.8.1.0 Introduced on C-Series Usage The display reflects the settings implemented with the cam-acl command. Information Example Figure 10-1. Command Output: show cam-acl (default) Force10#show cam-acl -- Chassis Cam ACL -- Current Settings(in block sizes) L2Acl : 5 Ipv4Acl : 6 Ipv6Acl : 0 Ipv4Qos : 1 L2Qos : 1 -- Line card 4 -- Current Settings(in block sizes) L2Acl : 5 Ipv4Acl : 6 Ipv6Acl : 0 Ipv4Qos : 1 L2Qos : 1 Force10# Content Addressable Memory (CAM) | 385