Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 457
interface range, interface null Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 457 highlights
Example Version 7.5.1.0 Version 6.4.1.0 Introduced on C-Series Introduced Figure 15-8. interface null Command Example Force10(conf)#interface null 0 Force10(conf-if-nu-0)# Usage Information Related Commands You cannot delete the Null interface. The only configuration command possible in a Null interface is ip unreachables. interface interface loopback interface port-channel interface vlan ip unreachables Configure a physical interface. Configure a Loopback interface. Configure a port channel. Configure a VLAN. Enable generation of ICMP unreachable messages. interface range c e s This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration). Using the interface range command, identical commands can be entered for a range of interface. Syntax interface range interface , interface , ... Parameters interface, interface, ... Enter the keyword interface range and one of the interfaces - slot/port, port-channel or VLAN number. Select the range of interfaces for bulk configuration. You can enter up to six comma separated ranges-spaces are not required between the commas. Comma-separated ranges can include VLANs, port-channels and physical interfaces. Slot/Port information must contain a space before and after the dash. For example, interface range gigabitethernet 0/1 - 5 is valid; interface range gigabitethernet 0/1-5 is not valid. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a port channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale and ExaScale • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults This command has no default behavior or values. Command Modes CONFIGURATION Interfaces | 457