Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 225

mac-source-address-mask count byte log monitor (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to log the packets. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Defaults Not configured. Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. Usage Information Related Commands When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. deny Configure a MAC ACL filter to drop packets. seq Configure a MAC ACL filter with a specified sequence number. seq c e s Assign a sequence number to a deny or permit filter in a MAC access list while creating the filter. Syntax seq sequence-number {deny | permit} {any | mac-source-address [mac-source-address-mask]} [count [byte]] [log] [monitor] To remove this filter, use the no seq sequence-number command. Parameters sequence-number deny permit Enter a number between 0 and 65535. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Access Control Lists (ACL) | 225