Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 767
ip pim sparse-mode, ip pim sparse-mode sg-expiry-timer
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 767 highlights
Command History Usage Information Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced on E-Series ExaScale Introduced on S-Series Introduced on E-Series Priority is stored at BSR router when receiving a Candidate-RP-Advertisement. ip pim sparse-mode c e s Enable PIM sparse mode and IGMP on the interface. Syntax ip pim sparse-mode To disable PIM sparse mode and IGMP, enter no ip pim sparse-mode. Defaults Disabled. Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.8.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series Usage Information C-Series supports a maximum of 31 PIM interfaces. The interface must be enabled (no shutdown command) and not have the switchport command configured. Multicast must also be enabled globally (using the ip multicast-lag-hashing command). PIM is supported on the port-channel interface. Related Commands ip multicast-lag-hashing Enable multicast globally. ip pim sparse-mode sg-expiry-timer c e s Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs defined by an access list. Syntax ip pim sparse-mode sg-expiry-timer seconds [access-list name] To disable configured timers and return to default mode, enter no ip pim sparse-mode sg-expiry-timer. Parameters seconds access-list name Enter the number of seconds the S, G entries will be retained. Range 211-86400 (OPTIONAL) Enter the name of a previously configured Extended ACL to enable the expiry time to specified S,G entries Defaults Disabled. The default expiry timer (with no times configured) is 210 sec. PIM-Sparse Mode (PIM-SM) | 767