Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1011

Usage Information Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when storm control thresholds are exceeded. storm-control multicast (Interface) c s Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only. Syntax storm-control multicast packets_per_second in To disable multicast storm control on the interface, use the no storm-control multicast packets_per_second in command. Parameters packets_per_second in C-Series and S-Series Only: Enter the packets per second of broadcast traffic allowed into the network. C-Series and S-Series Range: 0 to 33554431 S55 Range: 0 to 33554368 The minimum number of PPS limited on the S55 is 2 Defaults No default behavior or values Command Modes INTERFACE (conf-if-interface-slot/port) Command History Version 8.3.5.0 Version 7.6.1.0 Introduced on S55 Introduced on C-Series and S-Series storm-control unknown-unicast (Configuration) c e s Configure the percentage of unknown-unicast traffic allowed in or out of the network. Syntax storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile name]] [packets_per_second in] To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast [percentage decimal_value [in | out] | [wred-profile name]] [packets_per_second in] command. Parameters percentage decimal_value [in | out] E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the network. Optionally, you can designate a decimal value percentage, for example, 55.5%. Percentage: 0 to 100 0 % blocks all related traffic 100% allows all traffic into the interface Decimal Range: .1 to .9 Storm Control | 1011