Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 127
IP Prefix List Commands, clear ip prefix-list
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
ethertype operator count byte (OPTIONAL) To filter based on protocol type, enter one of the following Ethertypes: • ev2 - is the Ethernet II frame format. • llc - is the IEEE 802.3 frame format. • snap - is the IEEE 802.3 SNAP frame format. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. Defaults Not configured Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module deny permit Configures a filter to drop traffic. Configures a filter to forward traffic. IP Prefix List Commands When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. Use these commands to configure or enable IP prefix lists. • clear ip prefix-list • deny • ip prefix-list • permit • seq • show config • show ip prefix-list detail • show ip prefix-list summary clear ip prefix-list Reset the number of times traffic met the conditions ("hit" counters) of the configured prefix lists. Syntax clear ip prefix-list [prefix-name] Parameters prefix-name (OPTIONAL) Enter the name of the configured prefix list to clear only counters for that prefix list, up to 140 characters long. Command Modes EXEC Privilege Access Control Lists (ACL) | 127