Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 437
source port monitoring, Configuring a Port Monitor Source Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 437 highlights
source (port monitoring) Configure a port monitor source. Syntax source interface destination interface direction {rx | tx | both} To disable a monitor source, use the no source interface destination interface direction {rx | tx | both} command. Parameters interface destination direction {rx | tx | both} Enter the one of the following keywords and slot/port information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Enter the keyword destination to indicate the interface destination. Enter the keyword direction followed by one of the packet directional indicators. rx: to monitor receiving packets only tx: to monitor transmitting packets only both: to monitor both transmitting and receiving packets Defaults none Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Example Version 8.3.16.1 Introduced on M I/O Aggregator Figure 22-5. Configuring a Port Monitor Source Command Example FTOS(conf-mon-sess-11)#source tengig 10/0 destination tengig 10/47 direction rx FTOS(conf-mon-sess-11)# Port Monitoring | 437