Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 221

gvrp enable Enable GVRP on physical interfaces and LAGs. Syntax gvrp enable To disable GVRP on the interface, use the no gvrp enable command. Defaults Disabled Command Modes CONFIGURATION-INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands disable Globally disables the GVRP. gvrp registration Configure the GVRP register type. Syntax gvrp registration {fixed | normal | forbidden} To return to the default, use the gvrp register normal command. Parameters fixed normal forbidden Enter the keyword fixed followed by the VLAN range in a comma separated VLAN ID set. Enter the keyword normal followed by the VLAN range in a comma separated VLAN ID set. This is the default Enter the keyword forbidden followed by the VLAN range in a comma separated VLAN ID set. Defaults Default registration is normal Command Modes CONFIGURATION-INTERFACE Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module The fixed registration prevents an interface, configured via the command line to belong to a VLAN (static configuration), from being un-configured when it receives a Leave message. Therefore, the registration mode on that interface is fixed. The normal registration is the default registration. The port's membership in the VLANs depends on GVRP. The interface becomes a member of VLANs after learning about the VLAN through GVRP. If the VLAN is removed from the port that sends GVRP advertisements to this device, then the port will stop being a member of the VLAN. Use forbidden when you do not want the interface to advertise or learn about VLANs through GVRP. GARP VLAN Registration (GVRP) | 221