Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 666
disable, hold-time, Syntax, Defaults, Command Modes, Command, History, Usage, Information, Related
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 666 highlights
www.dell.com | support.dell.com disable Disable a VRRP group. Syntax disable To re-enable a disabled VRRP group, use the no disable command. Defaults VRRP is enabled. Command Modes VRRP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command Information and enter no disable. Related Commands virtual-address Specifies the IP address of the virtual router. hold-time Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the new switch can stabilize its routing tables. Syntax hold-time seconds To return to the default value, use the no hold-time command. Parameters seconds Enter a number of seconds. Range: 0 to 65535. Default: zero (0) seconds. Defaults zero (0) seconds Command Modes VRRP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module If a switch is a MASTER and you change the hold timer, you must disable and re-enable VRRP for the new hold timer value to take effect. Related Commands disable Disables a VRRP group. 666 | Virtual Router Redundancy Protocol (VRRP)